FINAL CHRISTMAS ORDERS FOR AUSTRALIA TAKEN ON DECEMBER 4TH

The Process

Stage 1 - CASTING

Stage 1 - CASTING

The initial stage of the CHD production process starts with a wax injection into the ring mould, to produce the wax piece for re-sizing and touch ups. Next, using the technique known as Lost Wax Casting, we cast the wax piece into the chosen alloy; either 925 Sterling Silver or 9ct Yellow/White/Rose Gold. This is done at Palloys Group, Sydney.

Stage 2 - OXIDISING

Stage 2 - OXIDISING

The second stage begins once we receive the cast piece back from Palloys Group. We start by oxidising the ring in Liver of Sulphur, which will darken the ring and to ultimately enhance design elements in the piece. This is seen in the blackened areas within certain parts of the design.

Stage 3 - DE-BURRING AND PRE-POLISHING

Stage 3 - DE-BURRING AND PRE-POLISHING

The foundations of the final look are set in this stage.This part of the process is therefore integral to achieve the ideal finish. We begin with de-spruing and de-burring the piece to of any large rough areas or inconsistencies. We then go over the surface with emery and a series of abrasives to prepare the raw silver for the polish.

Stage 4 - STONE SETTING

Stage 4 - STONE SETTING

After the general surface improvement has been made to the ring, we will set the stone or solder the other elements to the ring (if necessary to your design). Your stone will be either set in a bezel (such as in the Cushion ring design) or a hammerset (such as the small 2mm diamond on the Round Signet). The walls of the stone setting will sit on the angled area of the gem, to hold it in place.

Stage 5 - FINISHING

Stage 5 - FINISHING

The fifth and final stage, we impart the desired surface finish (either matte, oxidised or high polish). First, a preliminary buff is undertaken with the polishing compounds Tripoli and White Diamond, which begins to bring out the ‘mirrored look’. This is followed by the final polish with blue or green rouge compounds, to complete the high luster finish. Finally, we then run the piece through ultra-sonic and steam cleaners.

Job, Done.